#SENNHEISER EW100 G2 MANUAL PDF MANUALS#
#SENNHEISER EW100 G2 MANUAL PDF FULL#

Equipment The ceiling-mounted projector is Panasonic model PT-VX500EA. If this feed is taken from a modern laptop, its audio output may be from a combination audio-mic 4-section socket, and the audio output will then need to be separated by an audio-splitter cable into its two components of audio output and microphone input. jack plug (now often referred to as a 6.35mm plug). Additional audio input This can be plugged into any of Channels 4-6 of the mixer via a standard 3-section 1/4in. for the bodypack transmitter, as for the receiver at e. for the hand-held microphone, as for the receiver at e. To unlock a transmitter If either transmitter is locked, this status will be shown by a closed padlock or a key on its display panel. Then press the 'SET' button then the 'UP/DOWN' button to change the lock mode, 'SET' to store this, and 'UP/DOWN' to 'EXIT' this menu.į.

If the receiver is 'locked' (indicated by a padlock or a key on its display panel), it may be unlocked by pressing the 'SET' button to view the menu, then the 'UP/DOWN' button until 'LOCK' is displayed. Manual tuning of a receiver is done by repeatedly pressing the 'UP' or 'DOWN' button at the right of the receiver's front panel until the required frequency is displayed on the receiver. If there is a discrepancy, either the rack-mounted receiver or the hand-held transmitter may be re-tuned manually. It is therefore necessary to check that each microphone in use operates at the same frequency as its corresponding receiver, and this can readily be done by comparing the frequency displayed on the receiver with that displayed on the microphone. To synchronise frequencies The two rack-mounted receivers housed in the equipment enclosure and the two mobile transmitters associated with the microphones can each be set to different frequencies within the 830-866MHz operating band. Check that the level control for each separate channel in use is at its '0' mark (at 2 o'clock on its control on the front panel) before adjusting the audio balance between the channels in use and the overall sound level.

Channels 1 and 2 are reserved for use for wireless reception from the microphones, but Channels 4-6 remain available to receive other audio inputs.

On the mixer unit there is a 'Level' control for each of the 6 channels, as well as a 'Main Level' control at the right which adjusts all channels.

The battery status is good if the red LED light (on the base of the hand-held microphone or to the right of the display panel for the bodypack transmitter) is lit steadily and is not flashing.

The microphone to be used should be tested and its batteries replaced if faulty.

Connect the 4 audio output cables, connect and apply the mains, and check that all four units are 'on': the two receivers at the top of the enclosure and the mixer-amplifier at the bottom are normally left switched 'on' at their rear panels, but the switch for the loop amplifier is on its front panel - don't overlook this one.

To prepare for use First, remove all electronic equipment from the top of the black enclosure to prevent unwanted acoustic feedback. The User Manual emphasises that these cables should be connected before the mains supply is applied to the equipment. Audio connections The 4 output cables from the mixer unit need to be connected to the wall-mounted sockets: two for the speakers and the two for the loop.

#SENNHEISER EW100 G2 MANUAL PDF MANUALS#

Manuals We have downloaded the instruction manuals for the mixer and for the EW100 G2 system. The Sennheiser system consists of two EM100 G2 wireless receivers operating in the 830-866MHz band, a hand-held microphone (SKM100 G2), and a bodypack transmitter (SK100 G2) with clip-on microphone.ī. Equipment The audio equipment consists of a Sennheiser EW100 G2 system, a Samson S6 mixer amplifier, and a loop amplifier, all mounted in a black enclosure which is about 1 metre cube and fitted with castors for ease of moving. Note that all equipment should be left after use in exactly the same state as it was originally found. Together with the detail of the equipment and the hints garnered from the various manuals we also include below several tips drawn from our own use of the equipment.

#SENNHEISER EW100 G2 MANUAL PDF FULL#

This note helps us make full use of the audio-visual facilities available to us at the hall, so that the facilities that we can offer to speakers at our talks meetings are as comprehensive as possible, and so that our setting-up of the equipment is straightforward and confident. The audio-visual facilities of the WVCA Hall

Sennheiser ew100 g2 manual pdf